Instructables

Print Out Overhead Watch Light [Cheap and Easy and Solder-less ]

Featured

Step 2: Cutting

I will be using the third largest print for my watch. Cut out your print along the outside edge. (Ignore latch tabs in the pictures) Once your print is cut out, cut along the lines inside the battery circle. Finally, cut out the center circle which will allow your watch to be seen. Feel free to alter the thickness as I did.
 
Remove these adsRemove these ads by Signing Up
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!