Instructables
Picture of Project B
P1030177.JPG
P1030179.JPG
This is Project B. It uses a tubular mag underneath the gun that you load like a shotgun. It uses the same stock as Project A and shoots white rods.
tytiger332 years ago
I'd tell you to post it but you probably broke it up by now.
Johnhall44 (author)  tytiger332 years ago
i take pics of the inside of the gun so i can rebuild it later so i just have to find the pics
Oh... YAY!!!
Please post those pics when you find them.
Johnhall44 (author)  tytiger332 years ago
ill try to
Ok.
Johnhall44 (author)  tytiger332 years ago
sorry couldn't fin them D=
Ok.
Johnhall44 (author)  tytiger332 years ago
i continue to try and find them and rebuild and post when i do
Had any luck yet?
Johnhall44 (author)  tytiger332 years ago
i haven't had much time to search and build but yes I found them =D im thinking about improving it some too after I find the time to build =D
That's great! I hope you get the time soon.
What this gun needs is a whole new stock without the tiny thumb hole or even better, a properly angled handle. And your gun lacks a basic but very required part: a pin-guide.
A pin guide isn't required but definitely put something on it to make it easier to pull back.
Johnhall44 (author)  DJ Radio2 years ago
I agree with you on the pin guide idea but I dont know if I'll have time to because im working on a clip fed shot gun that has an internal firing mech so you dont have to worry about a firing pi sticking out of the gun :D
mag-/magazine fed. A clip is something like you load into an KAR-98K, simonov SKS or m1 garand.
It's pretty annoying when someone messes that up
Johnhall44 (author)  dr. richtofen2 years ago
its a mistake that is very confusing,because everyone is confused on the difference XD
sorry for double posting
mag-/magazine fed. A clip is something like you load into an KAR-98K, simonov SKS or m1 garand.
It's pretty annoying when someone messes that up
Johnhall44 (author)  beanieostrich2 years ago
Ya I know it needs a better stock, I was thinking about trying a m16 stock eventually but I dont know when I'll get to doing that....
Johnhall44 (author) 2 years ago
dont just rate this without adding a comment on what I should do to improve this!!