Print PDF
Favorite
Email
Step 9Making the shirt
Export the shirt as a 3ds-file with the rectangle and do the same procedure as in step 3. Again do the cutting lines vertically and symmetrically. Don't forget to add flaps to the arm- and leg-holes.
Make 2 plates of cardboard with a hole that fit on the bottom of the shirt as an artificial hip. You can see them on the picture. This makes it a lot easier to join the final 2 parts at the end.
It is up to you whether you already attach the head. If you are not sure, don't attach it yet.
Make 2 plates of cardboard with a hole that fit on the bottom of the shirt as an artificial hip. You can see them on the picture. This makes it a lot easier to join the final 2 parts at the end.
It is up to you whether you already attach the head. If you are not sure, don't attach it yet.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
