Push-Start a Comatose Furby

Step 8 Let Furby Recover

Now that Furby is awake, give him time to recover while watching his motor run. Incredible isn't it? As fun as it is to watch, you need to let Furby go back to sleep, so let him rest for awhile. Now that Furby is asleep, gently pick him straight up, and holding him upright, remove the screw holding the battery cover and open the cover. Try not to wake Furby! Now remove a battery so he doesn't wake up during the reassembly process. If you removed the left cover (I know you did) put it back on by gently slipping the ear through the slot and aligning the screw holes. Insert the two screws that holds it in place. Now insert the right ear through the ear slot of the right cover. Now lay the cover on the table, and gently push the microphone back into its holder. Then insert the back rub actuator into the right cover slot. The long tab on the actuator goes up. Now align the actuator to the left cover while placing the right cover back onto the Furby. Proper alignment is shown in the last picture on this step. Once everything is in alignment, insert the four screws that holds the cover in place.