Print PDF
Favorite
Email
Step 7Add some bracing and paint the bottom...
Our used table is made from a sheet of 1/2in MDF, and it's a little too flimsy for my taste. So, we simply added some 2x4's as bracing, in a rectangle around the LCD opening.
Now, this part isn't required, but if you're about to mount an LCD in the middle of your poker table, I promise that the first thing your friends are going to do when they see it is drop down and look underneath.
So, we just put a single coat of flat black spray paint on the underside of the playing surface and the bracing. We didn't think anything more was needed, since it should be dark under there most of the time anyway.
Now, this part isn't required, but if you're about to mount an LCD in the middle of your poker table, I promise that the first thing your friends are going to do when they see it is drop down and look underneath.
So, we just put a single coat of flat black spray paint on the underside of the playing surface and the bracing. We didn't think anything more was needed, since it should be dark under there most of the time anyway.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
