Pyramid Jig - Equilateral Triangle

2,300

40

3

Posted in WorkshopWoodworking

Introduction: Pyramid Jig - Equilateral Triangle



Share

    Recommendations

    • Casting Contest

      Casting Contest
    • Woodworking Contest

      Woodworking Contest
    • Make it Move Contest

      Make it Move Contest
    user

    We have a be nice policy.
    Please be positive and constructive.

    Tips

    Questions

    3 Comments

    Quality work.well done! could have done with you when I built my hex shed. it was and angle nightmare.. was going to build some corbels on each corner but the angles defeated me.

    If you put a cleat(s) on the bottom to ride in the miter guide slot then you don't risk an error if you fail to hold it tight to the rip fence. Also this will permit larger workpieces without problem of point hitting fence. Of course it does require getting the cleat the right size and putting it on strait...not to hard to make it adjustable over a small range though.

    1 reply

    You are absolutely right. I'm using slices of 15mm ply as rails for another jig, and will glue some on today! Thanks for the message!