Print PDF
Favorite
Email
Step 2Assembly
This really is pretty simple,
Step 1: Take the pill bottle and drill a whole in the bottom of it, the hole should be the same diameter as the pen or maybe a tiny bit smaller. You want to keep the hole small so that when the barrel goes into it theres not a lot of apace around it.
Step 2: Take your pen apart, all you need from it is the plastic tube body. Take the tube and fit it into the hole that you drilled into the pill bottle, and then slap some of the PVC Glue on that, make sure you seal up all the cracks, otherwise the gun will not work.
Step 3: If your using the grill lighter as a sparker: drill two very small pilot holes for the screws to go into. Then screw the screws into the hole leaving them stick out a little bit, you want the tips of the screws about 1/8 inch apart, if they're too far apart or if they're touching , it won't spark.
Step 4:Then take your wires from the sparker and attach them to the screws, and test to see if it sparks if it doesn't adjust the screws until it works then take the wires off the screws and PVC glues the screws in place, this also seals the bottle better, and then reattach the wires to the screws.
:Edit:
Step 5: I finally made one with an lanter sparker in it, it took awhile but it works quite well. The only problem is that i can't get hair spray work with the sparker, but i found a solution. Gasoline, simply dip the end of a Q-tip into some gas so it soakes it in, then swab the bottle in one complete circle around the inside with the gasoline soaked Q-tip, then close the cap put the Q-tip in the barrel and fire.
Step 1: Take the pill bottle and drill a whole in the bottom of it, the hole should be the same diameter as the pen or maybe a tiny bit smaller. You want to keep the hole small so that when the barrel goes into it theres not a lot of apace around it.
Step 2: Take your pen apart, all you need from it is the plastic tube body. Take the tube and fit it into the hole that you drilled into the pill bottle, and then slap some of the PVC Glue on that, make sure you seal up all the cracks, otherwise the gun will not work.
Step 3: If your using the grill lighter as a sparker: drill two very small pilot holes for the screws to go into. Then screw the screws into the hole leaving them stick out a little bit, you want the tips of the screws about 1/8 inch apart, if they're too far apart or if they're touching , it won't spark.
Step 4:Then take your wires from the sparker and attach them to the screws, and test to see if it sparks if it doesn't adjust the screws until it works then take the wires off the screws and PVC glues the screws in place, this also seals the bottle better, and then reattach the wires to the screws.
:Edit:
Step 5: I finally made one with an lanter sparker in it, it took awhile but it works quite well. The only problem is that i can't get hair spray work with the sparker, but i found a solution. Gasoline, simply dip the end of a Q-tip into some gas so it soakes it in, then swab the bottle in one complete circle around the inside with the gasoline soaked Q-tip, then close the cap put the Q-tip in the barrel and fire.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
