Introduction: Quick Last Minute Bloody Tooth-Picked Wound SFX

Picture of Quick Last Minute Bloody Tooth-Picked Wound SFX

In this project you will now how to make a quick last minute SFX tooth picked wound. Enjoy.

Step 1: Materials

Picture of Materials

Here is what you will need for this project:

A tissue or paper towel.

Tooth pick.

Dick Blick Block Printing Ink paint (red).

Makeup sponge.

Step 2: Towel

Picture of Towel

First, put a towel over your finger/thumb.

Step 3: Small

Picture of Small

Next, put a small bit of paint.

Step 4: Spreading

Picture of Spreading

Then spread it a little bit.

Step 5: Should Look Like This.

Picture of Should Look Like This.

Your bloody wound is not done yet, but should look like this so far.

Step 6: Tooth Pick

Picture of Tooth Pick

Split your tooth pick into two pieces.

Step 7: Adding Your Tooth Pick

Picture of Adding Your Tooth Pick

Now your going to just going to push the tooth pick (non sharp side) onto your wound. if it does not stick, you can add glue/hot glue (be careful). You can even add the other half on the bottom.

Step 8: Done

Picture of Done

There you go. Done. This is what your quick prop may look like if you copied off this project. You can even add a little bit of water drops to moist your prop. Or even if you have some fake blood, put a little bit on. Do what ever you want. This was just and idea, and was not meant to be perfect. I hope you enjoyed.

See my other instructable:


Puppygirl333 (author)2016-10-09

this,is cool I guess ?

Thank you?

About This Instructable




Bio: Hi. I'm Sebastian. I like SFX makeup. I love scary guts and gore. I like electronics. I also am a film/photo artist. :) YouTube ... More »
More by SebastianlpInstructables:Head-shot Wounded Lego MinifigureHow to Make a Rat Eating a Cockroach PropDIY Baby Monster Pumpkin
Add instructable to: