Introduction: Quick and Nerdy Phablet Pocket

Picture of Quick and Nerdy Phablet Pocket

I made a pocket that fits my Galaxy Note II, so I never have to worry about sitting on my phone and breaking the screen again. 
Basically, use a piece of paper to measure the size, (make sure you leave room to fold the edges) and cut the fabric. Trivial sewing, but I double stitched it to make sure it is secure. 


About This Instructable




More by cfishy:3D Printed Custom Funnel3D Printed Hex Bit HandleTabletop Hydroponics With 3D Printed Ebb and Flow Fittings
Add instructable to: