Introduction: RBG Alpha Repeater

Picture of RBG Alpha Repeater

Not much kinda copied off the RBG Repeater and I want to credit the creator of the repeater the most but this has a safety, scope, handle, bipod, butt styleing, and grenade

Step 1: Beginning the Process

To start building the RBG Alpha Repeater go to https://www.instructables.com/id/EAN8MTM5A2EV2Z8SGD/

Step 2: Building the Scope

Picture of Building the Scope

Get 8 half sherical knex pieces put 4 on the four poen rods in the center of the gun thenput a piece on top of the other sherical piece then take the inch long rods attach them upward in the center then put a circular piece at the top then put 3-inch rods in the open spaces of the two different scope spines.

Step 3: Building the Handle and Bipod

Picture of Building the Handle and Bipod

First take two circular pieces and attach 4 5-inch rods on the sides of the circular pieces move the circular pieces to the end of the rods put another rod at the bottom sticking out in the front more then take a stub piece and 1-inch rod and attach it to the bottom rod then take two circular pieces and attach them to the 1-inch rod after take the circular piece behind the front one and attach it to the barrel after take 2 5-inch rods and attach them to the front rod

Step 4: Building the Butt Attachment

Picture of Building the Butt Attachment

At the end of your gun attach 2 1-inch rods to the open space at the butt then take half circular pieces and attach them till they reach about a third the way up the butt on both sides then take another half circular piece and attach it outside the butt then take a 1 1/2-inch rod and point it upward 60% then take a 1-inch rod and point it downwards then put a half circular piece and attach it to the center of the gun repeat this step on the opposite side

Step 5: Building the Grenade Attachment

Picture of Building the Grenade Attachment

First attach a circular piece with a gap in one slot to a open rod sticking out somewhere near when the butt meets the body of the gun then take three of the same pieces and attach 6 2-inch rods to the sides of the pieces then take a half circular piece with a gap and attach it to the top circular piece then take a quarter circular piece and connect it to the half circular piece on the top then attach a stub to the quarter circular piece finaly attach the granade the cincular piece sticking out of the gun

Step 6: CONGRADS! You Finished the Gun

Picture of CONGRADS! You Finished the Gun

You finally finished the gun to see more instructables made by Erikthegreen visit his webpage

Comments

gunmaster222 (author)2008-09-13

cool !

halomaster007 (author)2008-01-09

very nice. works well!

MrRadicalEd (author)2007-12-05

I appreciate your effort to make credit where credit is due. My design still has a safety to prevent trigger movement, but kudos on creating a bipod and more rifle-like!

kalot (author)2007-08-23

i need to knw b4 i build it, does it shoot pieces or rubber bands?

Kaiven (author)kalot2007-09-18

rubberbands, it's an RBG, which stands for Rubber Band Gun

halo99 (author)2007-08-30

hi

Eat My Shots (author)2007-08-17

Woop 3rd comment! (So What!) (No offence)

T-man (author)2007-08-15

looks cool 2nd comment

Vynash (author)2007-08-14

wow

About This Instructable

2,550views

3favorites

License:

Bio: I like legos alot and im very creative.
More by Erikthegreen:Xbox 360 headset holderXbox 360 controller holderRBG Alpha Sniper Repeater
Add instructable to: