Introduction: RDM Device Emulator

Picture of RDM Device Emulator

About a year ago I bought a cheap DMX RGB wall washer , but it had a set DMX address so i decided to build an RDM Emulator.

Step 1: Gather the Parts

Picture of Gather the Parts
You will need
  • 2 x MAX485
  • 1 x 100 OHM resistor
  • 1 x 4.7 k resistor
  • 1 x Arduino rev3
  • Jumper wires
  • 1 x Breadboard

Step 2: Build the Circuit

Picture of Build the Circuit

Step 3: Arduino Code

You will need to install the DmxSerial2.h and the DmxSimple.h arduino library's.

Then you can upload the arduino code to your arduino uno rev3.

Step 4: You're Done!

Comments

About This Instructable

558views

3favorites

License:

More by DavidB56:Usb to DMX-RDM InterfaceArduino RDM RelayRDM Device Emulator
Add instructable to: