Step 1: ASSEMBLE THE CHASSIS

U CAN MAKE THE CHASSIS OUT OF ANYTHING U WANT.WE HAVE USED EBOT PLASTIC BRICKS.ATTACH THE DC MOTORS TO THE CHASSIS.THE DC MOTORS ARE CONNECTED TO THE EBOT CONTROL BOARD.

Step 2: PROGRAMMING THE EBOT

WE HAVE USED EBOT BLOCKY TO PROGRAM THE ROBOT .THE PICTURE OF THE PROGRAMMING DONE IS GIVEN ABOVE.YOU CAN ALSO USE ARDUINO TO PROGRAM THE ROBOT.

Step 3: ADD BATERRIES AND FINISHING TOUCHES

WE HAVE USED 6 AA BATTERIES WHICH HAS BEEN STUCK TO THE BASE OF THE CHASSIS.
SINCE ONLY THE TWO WHEELS IN THE BACK ARE BEING CONTROLLED,YOU CAN EITHER PUT UP TWO WHEELS IN FRONT FOR SUPPORT OR USE EXTENSIONS IN THE FRONT AND ADD ONE WHEEL TO IT.(AS SEEN IN THE PIC ABOVE)