Introduction: RGB Human Circuit

Picture of RGB Human Circuit

When you touch the leads on this circuit it flashes Red, Green, and Blue.

This Circuit was collaboratively built by Me and my Friend Cass.

Step 1: Gather Your Parts

Picture of Gather Your Parts

You will need:

Breadboard

Breadboard Wires

Arduino (needs 4 I/0 pins

NPN transistor

3 leds (red, green, blue) or and RGB led

3 560R Resistors

1 10k Resistor

Step 2: Build Your Circuit

Step 3: Program the Board

Here is the program:

int readPin = 10;
int ledR = 9; int ledG = 8; int ledB = 7;

void setup(){ pinMode(readPin, INPUT); pinMode(ledR, OUTPUT); pinMode(ledG, OUTPUT); pinMode(ledB, OUTPUT); }

void loop(){ while(!digitalRead(readPin)) { digitalWrite(ledR, HIGH); delay(50); digitalWrite(ledR, LOW); digitalWrite(ledG, HIGH); delay(50); digitalWrite(ledG, LOW); digitalWrite(ledB, HIGH); delay(50); digitalWrite(ledB, LOW); } }

Comments

MsSweetSatisfaction (author)2015-01-12

What a fun gizmo, must be cool to see the electricity running through via the LED. Welcome to instructables!

Thanks. Also my friend made this with me

About This Instructable

984views

7favorites

More by NoahT3:RGB Human Circuit
Add instructable to: