So Without further-a-do Lets get started....
Step 1: Supplies
RGB segments - Ebay (I only ordered this exact one, and it appears that you get one
unit, but I was sent two ??)
12V DC power supply - Free (My box of spare power supplies, An every Geek Must have)
And finally Somewhere to mount the led segments.
Cm'on Be inventive, A Fish tank, Behind a Tv, RC car, under the Bed, On a Shelf, In a computer case And im sure there's lots more!.
For this I just used a small scrap of wood so I could be portable and mount the leds anywhere I wanted
So after you've gathered your materials glue gun the wires from the led strips into the output pin, Make sure there in the correct position! (directions on the sticker on the led controller)
After you've done the above Move onto step two: Mounting the leds