COMPLETING THE ROBOT.
AFTER THE PARTS ARE CUT OUT AND SANDED AND PAINTED-
Attache the T-nuts as shown.
Attach Shoulder Rotators with wood screws tightly.
Attach the two leg rotators with the wood screws.
Then attach all other parts of legs and arms.
Do the Head last .
See figure if you use a LED flasher . Attach to back and run wires to back hole to nose. Solder on a red Standard size LED. observing polarity. An AA battery is placed in the clip . It will not need a switch as the led is always on. It should run for 2 years. Glue the LED into the Nose hole.with RTV silicone rubber.
When completed you can tighten or loosen the machine bscrews to move the arms , and feet.