ROV submersible (PVC)

Step 8 Mounting the camera

Step 8:
(mounting the camera into the housing)

--- I removed the original stand from the webcamera and replaced it by my own, smaller version.

---I also epoxy glued a nut to the camera housing so i could bolt the camera.

---Then i drilled 5 holes in the back lid:
1-for the camera wire to the surface
1-for the power wire to the surface
3- for te motors.

Comments

[Danny_Payne]

Hiya! how long and wide was the camera housing, and also, how big was the sheets of pexiglass?

Thanks!

[daniel2008]

 my plexiglass was 0.5 cm thick, and the pieces were 11x11cm, big enough to fit the 9cm diameter pipe which was also ~ 13cm long.