3 Simple Ways to Share What You Make
With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Create on the go:
With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Hi everybody and welcome to my Instructable... If you like it please vote...Thanks... I found this old ceiling fan on the side of the road. I to...
I then cut a hole in a piece of plywood so the bottom of the motor would fit in. I then made up the sides so as this would form a base,...
I then made up a sort of clamp where the pole used to fit. I was going to use the original pole but was made of plastic and may not have been strong e...
I used the piece ply I cut out earlier (to fit motor in) over the top of the poles to hold everything up. I used epoxy to hold it there. I them mad...
I fitted a short piece of chain to the small pole. I hooked this onto the cup hook in the top platform. This gave me a flexable joint so if the helico...
I fitted a clamping device to hold the helicopter down.
There is it doing what it is supposed to... Watch video,,,, HERE...
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Remove these ads by
Visit Our Store »
Go Pro Today »
Nice helicopter, I was given 2 large nitro models last year one with engine but no servos, and one in an even more incomplete state.
They are due to be dismantled so they can donate their bearings and linkages for a a couple of stationary engines.
The training stand would still not be enough for me to restore the 2 I was given. I just know they would eventually crash on me and all the work would be in vain.