Print PDF
Favorite
Email
Step 4Setting the Element Spacing
Cut a piece of pipe 11 inches and another at 7 inches. Sand any burrs from the ends. These will set the spacing nicely.. I didn't "glue" anything.. they're held together by a tight fit.
The 7 inch section goes between the reflector and driven elements.
The 11 inch section goes between the driven elements and the director.
The 7 inch section goes between the reflector and driven elements.
The 11 inch section goes between the driven elements and the director.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
