Instructables

Rainbow Loom Flower Ring

Picture of Rainbow Loom Flower Ring
 
Remove these adsRemove these ads by Signing Up

Step 1: Step One

Picture of Step One
Add two rubber bands to the loom to begin the ring.

Step 2: Step Two

Picture of Step Two
Place the first two loops that begin the flower , first the left and then the right one.

Step 3: Step Three

Picture of Step Three
Place the next two band , starting with the right and then the left one.

Step 4: Step Four

Picture of Step Four
13, 2:25 PM.jpg
Place the next two bands on the loom - order is not important here.

Step 5: Step Five

Picture of Step Five
13, 2:26 PM.jpg
Place the next two bands - left and then right.

Step 6: Step Six

Picture of Step Six
13, 2:26 PM.jpg
Place the next two bands - right and then left

Step 7: Step Seven

Picture of Step Seven
Add three single bands to the end. This will form the rest of the ring portion that will go around your finger.

Step 8: Step Eight

Picture of Step Eight
Working from the end with the three single bands on the bottom, loop the second an third ones upward.

Step 9: Step Nine

Picture of Step Nine
Now you can start looping the flower portion. Make sure the two single loops are on the bottom when you start this.

Loop the one to the left first, and then the one to the right.

Step 10: Step Ten

Picture of Step Ten
Loop the two inner band on the top, first looping in from the left to the right, and then right to left.

Step 11: Step Eleven

Picture of Step Eleven
Now loop the side bands downward - order is not important here.

Step 12: Step Twelve

Picture of Step Twelve
Loops the inner bands on the bottom is a little different. Working from the middle pin, loop the one towards the left first , and then towards the right.

Step 13: Step Thirteen

Picture of Step Thirteen
Loop the two bottom bands - left inwards, and then right inwards.

Step 14: Step Fourteen

Picture of Step Fourteen
13, 2:26 PM.jpg
I forgot to take a picture of this step , but remember to loop the last two single bands that will complete the ring for your finger.

Attach a clip to this end BEFORE taking the ring off the loom. This will prevent it from falling apart when you remove it.
Attach the other end to the clip and you have your finished product.