Introduction: Raspberry Pi Tutorial of LED Blinking

Requirement:

  • Raspberry Pi
  • BreadBoard or T-Cobbler
  • Jumper Wires
  • LED

Click here for More Information

Step 1: Connect Your Raspberry Pi GPIO With LED on Breadboard or Multi-function Board

Picture of Connect Your Raspberry Pi GPIO With LED on Breadboard or Multi-function Board

Now as per video you can use pin number 27 as output and connect GND with led's GND terminal,

Make sure your GPIO connection should be correct.

Step 2: Setup

Picture of Setup

Connect LED on breadbard or T-cobbler as attached video.

Step 3: Install GPIO Libraries

$ sudo apt-get update

$ sudo apt-get install python-rpi.gpio python3-rpi.gpio

Step 4: Program

import RPi.GPIO as GPIO

import time

LedPin = 11 # pin11

def setup():

GPIO.setmode(GPIO.BOARD) # Numbers GPIOs by physical location

GPIO.setup(LedPin, GPIO.OUT) # Set LedPin's mode is output

GPIO.output(LedPin, GPIO.HIGH) # Set LedPin high(+3.3V) to turn on led

def blink():

while True:

GPIO.output(LedPin, GPIO.HIGH) # led on

sleep(1)

GPIO.output(LedPin, GPIO.LOW) # led off time.sleep(1)

def destroy():

GPIO.output(LedPin, GPIO.LOW) # led off

GPIO.cleanup() # Release resource

if __name__ == '__main__':

setup()

try:

blink()

except KeyboardInterrupt:

destroy()

Comments

About This Instructable

45views

1favorite

License:

Bio: Advanced and latest technology tutorials on my youtube channel and now i started instructable so i will post one by one latest tutorial.
More by Tatsu Technologies:Control Led by Pushbutton | Raspberry Pi 3 | Tutorial - 2Raspberry Pi Tutorial of LED BlinkingIntroduction to Voltage, Current, Resistance and Power Explained for Beginner
Add instructable to: