Raygun - Steampunk Defense

Step 5 Grip

I started by sticking pieces of duct tape together to make a small sheet that's not sticky on either side. I wrapped it around the handle and marked it up to make a pattern. I used the pattern and cut a piece of leather. Then I used the curved needle and waxed sinew to stick it together.

Hey, guess what....there's a picture!

Comments

[rredmon]

if you soak your leather it's a lot easier to handle...and it will shrink a bit when it hardens, securing the hold on the handle...a little epoxy never hurts too. :D good structible btw.