85 Inch Rear Projection Wiimote IWB (Interactive White Board)

Step 3 Attaching Screen to Legs

I attached the Screen to the Legs, by drilling wholes through the Projector frame. Then I drilled matching holes into each leg (it is important to remember to drill your holes off centered on the legs so that you do not have any of the leg blocking the picture since it is rear projection)

Once all holes were drilled I ran Carriage bolts through the front of the screen holes and through the Leg holes. I used Wing nuts instead of regular nuts, so that I can take my screen apart and set it up without any tools.

Comments

[ajrisi]

 While I hate to nit-pick such a wonderful article, it should be noted that what you type as "whole(s)" should be "hole(s)". A "whole" refers to a single entity including all subcomponents without exception, while a "hole" is an opening into or through something.

Otherwise, very nice!