With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
I've seen many woven cuff bracelets made of fabric or paper. I wondered if a colorful soda can could be cut up and used, instead. Hmmmm...hence my ver...
Gather your supplies: A colorful can - I've used an Arizona fruit punch can(nothing like stating the obvious, eh?). Scissors Xacto knife pen piece of...
Had a little trouble thinking ahead...and realized halfway through that I also needed these supplies which were not pictured in my first step (althoug...
Measure and mark (I HATE measuring!) a 6" long x 1 1/2" wide rectangle on paper. This will be the size of the cuff bracelet. Cut it out and use it as ...
Using an Xacto knife (or scissors), cut into the top of the can, just below the rim to cut off the top of can. Slice in a sawing motion around the top...
With the right(colored) side of the aluminum sheet facing down, slowly roll the sheet over the edge of a table, to flatten it out. I had to do this 2...
Yes, the SHEET, not the...well...never mind! Turn the sheet lengthwise, and starting 1/4' down from the top and 1/4" in from the left side (have I ...
Using the piece of foam core board, line up the small pieces of the can that you just cut, and put a push pin in one end of them to hold them down. Le...
Turn over your woven piece and place one of the pieces of cardboard on it. Center the cardboard. Start bending the can strip ends over the cardboard. ...
(Findings are things like: jump rings, clasps, etc.) Lay the bracelet down, woven side up, and drill two holes on each (short) end. Make the holes ab...
Remove these ads by
Signing Up
Not NiceInappropriateSpam13,461 views
90 favorites
Posted:
Feb 15, 2011
License:
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »