Introduction: Removing 3D Printed Parts on a Cheap Plastic Tape!

I showed in another post how did I use a cheap plastic tape to print on with my 3D printer.

Now it's time to remove the parts and very easily! Watch the video to see how easy is that!

Step 1: Removing the Parts

Just don't pull the part up.. try to move it or bend it AFTER THE BED IS COOLED TO THE ROOM TEMPERATURE. carefully and it will popup in your fingers. Then you can remove the small lines (if there are some) so you can use the tape for many more times!

Happy printing!


About This Instructable




More by Rajaa Kahel:3D Printed Actual SpeakerDIY Portable Generator 3-In-One (Electricity From Heat)DIY Magnetic Jack/Plug For Any Purpose (No Soldering)
Add instructable to: