Print PDF
Favorite
Email
Step 6Remove the old nuts.
Clamp a stripped nut with a vise grips and using a 8mm wrench or socket wrench, remove the stuck screws, and remove the cover from the box.
Replace the old 6mm bolts in the cover with new 1/4"-20 stove bolts 1 1/4" or 1 1/2 " long.
Using one of the old bolts screw it into the old nuts and tap them out of the plastic box housing with a small hammer.
Your box housing should look like the last picture, and is ready for the bars.
Time for step 7.
Replace the old 6mm bolts in the cover with new 1/4"-20 stove bolts 1 1/4" or 1 1/2 " long.
Using one of the old bolts screw it into the old nuts and tap them out of the plastic box housing with a small hammer.
Your box housing should look like the last picture, and is ready for the bars.
Time for step 7.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
