Print PDF
Favorite
Email
Step 4Finally!
Getting all the points loose was difficult, partly because many of the leads had wires soldered to them below the circuitboard and it seemed to replenish the solder I removed. I heat sinked with alligator clips and paper clips in the tighter spots.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Oct 26, 2008. 5:08 AMwizrd4824
says:
If you use a little flux and some desoldering braid, this step will be a breeze. It will also avoid overheating the PCB and damaging the traces and pads.
Reply
 |
Add Comment
|
