Step 1: Removing the flint and disassembling your zippo
Step 2: Taking apart your dead BIC
Also, remove the saftey if you have one.
you can do both of these steps with a pair of needle nose pliers.
just grab, twist, and pull. both should come off fairly easily.
next, put the lighter in a clear plastic bag.
the lighter is spring loaded and if you don't take it apart in a clear plastic bag,
the parts wil fly out and be lost forever.
through the bag, grab the wheel with a pair of pliers.
carefully pull it to on side. after one side of the rod holding it in pops out,
it should come out easily. as soon as the wheel is removed,
the flint and spring will shoot out. the spring is about and inch to an inch and half long. the flint is about 3/32" in diameter.
Step 3: Cutting down the flint
it should look something like this.
you will have a dead lighter body, spring, wheel, sheild, and flint.
the only thing you will need for this project is the flint.
place the flint in a pair of wire cutters, (usually found on needle nose pliers.)
put the pliers back inside the clear plastic bag.
you will be cutting the flint in half (length wise) becusae it is about twice as long
as it needs to be. the purpose of the bag is to prevent the flint from shooting across the room. next, simply cut the flint in half.