Print PDF
Favorite
Email
Step 11Gluin' it down
Using hot glue (and gun) fill the base with glue , than quickly putting down the
array taking care that the Ground loop touches the body of the base .
let it harden for 15 minutes , and give a final test , Congratulations
array taking care that the Ground loop touches the body of the base .
let it harden for 15 minutes , and give a final test , Congratulations
You have finished your new LED bulb
| « Previous Step | Download PDFView All Steps | Next Step » |
4
comments
|
Add Comment
|
Nov 30, 2008. 10:49 PMSteveMcCraft
says:
This is very interesting. Thanks a lot! But I have read, that LED need a resistor to survive longer. How long has your construction worked? best to you Steve
Reply
19
Dec 1, 2008. 10:49 AM
acaz93 (author)
says:
acaz93 (author)
says:
over 3 months so far , yeah it needs a resistor to work the guarantee 10,000 hrs (that's described in the last step ), It's really robust ,someone dropped by bike and a bump appeared in the case but the LED bulb was intact. Thanks , Have a nice week!
Reply
Dec 1, 2008. 2:50 PMSteveMcCraft
says:
OH yes - now I have read the last page. All ist there. I am sorry for asking. Is it difficult to add a high Cap for making it light even without riding for a short time - but where and how? Allt the best Steve
Reply
19
Dec 1, 2008. 3:11 PMacaz93 (author)
says:
acaz93 (author)
says:
Yes! but you will need a Zener diode and really high cap (I mean like 0.55 F ) if you ive a day i'll make a schematic
Reply
 |
Add Comment
|
