You will be learing how to build a Rife Machine using a home or car amplifier. This project is for expirmental use only and not approved by the FDA.
Good site for more information http://dougcoilmachine.com/freestuff.html
Step 1: Materials List
1.) Wire: I used speaker wire for this project, however you can use regular insulated wire. I recomend 12 awg wire with a high heat rating. You will need at least 100 feet of wire.( 500 feet works best)
2.) 1 gallon bucket w/ handle
3.) 2 threaded rods 1/4 thick and 36 inches long
4.) 4 1/4 nuts
5.) 1/4 drill bit
6.) power drill
7.) pack of 24 inch Heavy duty ties
8.) nail clipper
Step 2: Coil Construction 1
Remove metal handle from 1 gallon plastic bucket.
Step 3: Coil Construction 2
Turn the bucket upside down and place a ruler on top of the hole where the handle use to be. I measured 3 1/2 inches, this means my coil will be 3 1/2 inches tall. You can make it shorter but I was using this powerpoint prentaton as a guidline. http://dougcoilmachine.com/freestuff.html
. Once the desired height is achieve mark it and make sure that it is in line with the bottom handle hole. Then drill the marking with your 1/4 drill bit. Then stick drill bit in the handel hole and drill all the way through. Make sure this is done for both sides.
Step 4: Coil Construction 3
Now that the 4 holes are drilled into each side of the bucket we can insert our rods. Insert the rods half way in the bucket then add 2 nuts for each rod. The nuts have to stay on the inside of the bucket, keep spining the nuts until rod protrudes evenly out of the bucket on both sides. You should now have a bucket with 2 rods sticking out that are firmly in place.