Introduction: River Tube Connector
Step 1: The Things You Will Need
nylon rope, duct tape, zip tie, pool noodle, scissors, clips and tubing.
Step 2:
Tie simple slipknot and one end of the rope.
Step 3:
Run the untied end through the noodle and tie the slipknot and that side as well.
Step 4:
Place the clips through the slipknots pulling them tight.
Step 5:
Place the tube on the clip. you may need to trim. this will ensure that to the clip does not come undone while on the river.
Step 6:
Take a small piece of duct tape and wrap it around the end of the slipknot.
Step 7:
Tighten the zip tie around the pool noodle to make the hole is smaller so the clips do not slip through while on the river
Step 8: The End Result
Have fun