Print PDF
Favorite
Email
Step 17Wheel three (The end of the motors and gears)
For this step you will need two black/white rod connectors, a small wheel, two white rods and a yellow rod.
First clip the white/black rod connector to the red rod you put there in step 16. Next put a whit rod through the hole and in to the pumpkin like shown in picture 2 and three. Repeat the same on the other side.
next slide a wheel on to the yellow rod and clip two tan clips on either side like shown on picture 5.
Note: You may need to reduce the weight on the pumpkin by cutting chunks of pumpkin out with an extremely sharp knife (picture 6)
First clip the white/black rod connector to the red rod you put there in step 16. Next put a whit rod through the hole and in to the pumpkin like shown in picture 2 and three. Repeat the same on the other side.
next slide a wheel on to the yellow rod and clip two tan clips on either side like shown on picture 5.
Note: You may need to reduce the weight on the pumpkin by cutting chunks of pumpkin out with an extremely sharp knife (picture 6)
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
