Instructables
Picture of Rollerblade Brake

I had worn out my rollerblade brake and had gone to the store to buy a new one. Unfortunately the brake i needed was not manufactured anymore. I didn't want to buy a new pair of rollerblades just for the brake so I decided I would have to figure out how to make my own. After some experimentation, this is what I came up with.

Materials needed are:

A hockey puck or any suitable hard rubber ($0.99)
A saw or something to cut the puck with (already had)
5 minute epoxy ($1.25)
Aluminum foil to make a mixing bowl
A mixing stick

You can experiment to find out what works best for you. I found 5 minute epoxy works the best. I tried other glues and silicone but the brake sheared off. It's also best to get the hardest puck you can as it will last longer. The puck will mark floors and other surfaces so be careful. Also the puck won't last as long as a regular brake but you can get four brakes out of one puck so it's okay.

Step 1:

Picture of
Image0217.jpg
Image0215.jpg

You will need something to cut the puck with. I used a hand saw.

Next, you will need something to glue the puck with. I found 5 minute epoxy seems to work the best.

And last, you will need a puck. Get the hardest puck you can because it will last the longest and not mark as much. You can see here that I already cut a piece out.

Step 2:

Picture of

You can see the worn out brake. Try not to let it wear out all of the way so there is something you can attach the puck to.

Step 3:

Picture of

Here you can see that I cut the puck into four pieces (already used one of them). You can cut the puck into any shape you like. I just do it this way because it's easier.
 
Remove these adsRemove these ads by Signing Up
n1cod3mus2 years ago
Intresting, i dont use a brake block i brake with my wheels wouldnt it have been easier to do that? I only use my brake block when im teaching.

but hey its still a good instructable for those who do use their brake blocks
wazzup1053 years ago
Nice. I bought some extra brakepads, but I am running out of them (only one left). Good to see something I can try before I put in that last one ! I heavily rely on my brakes. I know a lot of people don't, but I rather save my wheels and am way better at braking with a brakepad anyways. (like all wheels of the ground, just coming to a screeching stop standing on the pad alone :))
keokg2 (author)  wazzup1052 years ago
I rely on my brakes too. I would rather save my wheels like you. Brakes are far cheaper than wheels. Please be careful with these homemade brake pads though. Since they are epoxied and not a one piece brake pad, they might not handle as much stress as a commercial brake pad. I haven't had any problems though except for wearing them down too fast.

Thank you for the kind comment and good luck. If you try this, would you please let me know how it worked for you?
keokg2 (author) 3 years ago
Thank you for the kind comment. Unfortunately I seemed to have erased the comment by fixing a spelling mistake and re-publishing. I don't quite know how instructables works yet. But again, thank you.
keokg2 (author)  keokg22 years ago
This post was for a comment I accidentally deleted when I re-published.