loading

Step 2: Getting Started

I found a PCB that had lots of interesting traces on the portion I wanted to use.  I outlined my phone and cut the PCB down on my table saw to the proper proportions.  In my case, the width was critical for fit, but the height was arbitrary.  I ended up with an approximately 3" x 4" plate.

Advertisement

Nice finished look to it. Was the PCB just to make your phone fit tight enough not to fall out?
I used the recycled PCB as a structural element...it is the basic frame from which I added everything else

About This Instructable

11,569views

69favorites

License:

Bio: I reckon I was a maker before I knew we were called such. Growing up, my dad and I spent countless hours welding, cutting, banging ... More »
More by bigern00:Barbie Hand Sugru Prosthesis Recycled Tire Coffee Table Room Storage & Organization System 
Add instructable to: