Print PDF
Favorite
Email
Step 5Attach the bottom
Pic 1: This is what it will look like when you follow the below steps.
Pic 2
1. Place a few business cards between each piece of wood, for temporary spacers (unlike the picture, rip or cut them in half so they don't show and get in your way.
2. Place your bottom on the blocks, and mark where the pieces come together with pencil.
3. Use a straight edge to transfer those marks to the plastic. Mark where you want your drill holes about 1/2 inch in on each corner of the bottom (centered on each of the side rails)
4. Using a Dremel or small drill, drill pilot holes.
Pic 3
1. After all your holes are drilled,
2. use screws to attach the bottom.
3. Realize that you have a power drill, why am I doing this by hand??
4. Remove the spacers, and ensure the center piece moves freely.
Pic 2
1. Place a few business cards between each piece of wood, for temporary spacers (unlike the picture, rip or cut them in half so they don't show and get in your way.
2. Place your bottom on the blocks, and mark where the pieces come together with pencil.
3. Use a straight edge to transfer those marks to the plastic. Mark where you want your drill holes about 1/2 inch in on each corner of the bottom (centered on each of the side rails)
4. Using a Dremel or small drill, drill pilot holes.
Pic 3
1. After all your holes are drilled,
2. use screws to attach the bottom.
3. Realize that you have a power drill, why am I doing this by hand??
4. Remove the spacers, and ensure the center piece moves freely.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
