RumbleMouse

Step 2 Open and Drill

So the first thing we have to do is open up our mouse and find out where we can fit the motor without causing problems. If you're super lucky, you might be able to squeak the motor into the space without having to remove any outside material. Most likely though, you'll have to chop out a nice section to fit your motor.

We start by finding the spot on the outside of the mouse where we need to drill. Take a hole-saw bit thats a good 5mm ( 1/4 inch ) wider than the protruding motor head, and drill.

Plop the motor into place, and see how it looks so far.