We recently added wooden frames around the doors and windows in our beach house, made from a Brazilian hard wood called Angelim Pedra. We had lots of this beautiful hard wood left over from this project, and I decided to use it to make some towel racks. I hate to see good wood go to waste!;-)
Here's how I did it...
• scrap wood
• wood glue
• plastic screw anchors
• Hack saw
• Grinder (optional)
• Paint brush
• 13/16 wood bit
• rasp (or file)
• Screw driver
Step 1: Select and measure wood
The first picture above isn't the exact piece of wood I used, but from the same wood pile.
(This is a piece I used for my Steampunk Socket/Switchplates;-)
Step 2: Grind (or sand) wood
This is also a good time to drill two holes through the base, equidistant from each end, where we will later mount the rack to the wall.
Step 3: Cut end pieces
After you've cut two rectangular pieces (about 4 to 5 inches long) make diagonal cuts on the top of the ends that will face out, and then round the edges a bit with a sander, rasp or file.
(The picture above is of an end piece that I cut too short, but you can see the rounded edge).
Step 4: Prepare end pieces
I thought about different ways to assemble this rack, and realized I needed to mount it to the wall before I added the broom stick. (Otherwise the stick would interfere with screwing into the wall). To accomplish this, I decided to prepare the end pieces in such a way that I could slide the stick in after the rack was mounted. (Why does that sound so dirty?;-)
So what I did was use a 13/16 wood bit to create the hole. I drilled just far enough to create a small hole through the other side, to eventually put the screws which will hold the stick in place.
Then I used a hack saw blade to make slits from the drilled hole, to the bottom of these pieces, making sure that the space was slightly wider than the holes.
Once these guidelines were cut into the wood, I placed the piece in a clamp, placing the clamp upside down. The bottom part of the clamp I used fit perfectly into the drilled hole, and held the piece in place, while I chiseled out a track to slide the broom stick into.
After chiseling, I used a rasp to smooth out the slots.
Step 5: Assemble
As the wood I was working with is particularly hard, I didn't have to worry about it splitting, but you may have to find another way to attach the ends (maybe elbow brackets or hinges?) if you are using a more delicate wood.
Step 6: Paint and cut broom stick
I used a coffee colored (if you take your coffee with milk) enamel paint, which in Portuguese is called "Tabac," I guess because it has the appearance of dried tobacco. Select a paint color depending on your desired finished product.
Once the rack is assembled, lay the broom stick in place, and measure to make sure you have a tight fit, inside the end pieces.
Step 7: Varnish (or stain)
Step 8: Mount rack to wall
Measure the distance between the holes by placing the rack against the wall, and making marks (maybe with a nail or screw) through the holes in the wooden base. Once you have the plastic anchors in the wall, you're ready to mount the rack.