Introduction: SIMPLE LEATHER COIN WALLET
Simple coin wallet made from scrap leather.
It is fast and easy to do, even for somebody that never worked with leather before.
If you like it, please vote it in the contests!
Step 1: WHAT YOU NEED
-thick hide/leather scraps;
-snap button tool;
-hard plastic/wood surface.
Step 2: PATTERN
This is the simple pattern of the wallet, with the measurements, and the holes for the snap button.
Step 3: MARK
Mark the pattern on the leather.
Step 4: CUT
Cut the leather.
Step 5: PUNCH HOLES
Punch the holes for the snap button.
Step 6: BUTTONS
Place the snap button.
Step 7: GLUE
Glue the front and the back of the wallet.
(Optional. I do it just because this way it is faster to punch the holes all the way around without the two part of leather moving away from each other).
Step 8: PUNCH HOLES
Punch holes all the way around.
Step 9: START SEWING
Start sewing: pass with the needle in between the two layers of leather, let a little bit of thread out on a side.
Step 10: SEW
Sew all the way up on a side, than on the other side, than back where you started (see photos).
Do few more stitches more, so that it is not going to be unthread.
Step 11: FINISH SEWING
Exit again in between the two layers of leather.
Cut away thread left overs.
Step 12: DONE
You are done!
You don't feel like to make one? Here is the ones I sell!
jfine4 made it!
We have a be nice policy.
Please be positive and constructive.