Step 5: Cut the Kite and Feed Wires Through
1. Assemble your kite.
2. Poke a hole near the cross of the kite with scissors.
3. Feed your rope of wires through the hole.
4. Secure the PC board with Accelerometer to the kite. We secured it to the long, vertical piece, right below the cross.
How we secured it:
- Electrical tape to secure the accelerometer to the PC board.
- Wrapped bubble wrap around the accelerometer and PC board.
- Taped the whole thing down with duct tape.
2. Poke a hole near the cross of the kite with scissors.
3. Feed your rope of wires through the hole.
4. Secure the PC board with Accelerometer to the kite. We secured it to the long, vertical piece, right below the cross.
How we secured it:
- Electrical tape to secure the accelerometer to the PC board.
- Wrapped bubble wrap around the accelerometer and PC board.
- Taped the whole thing down with duct tape.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
