Instructables

Step 4: Red light bar

Picture of Red light bar
IMG_2402.JPG
IMG_2399.JPG
This was also a simple step. I had a hight intensity red l.e.d. and filed it down on both sides to make it flat. I also filed the light bar down to accept the l.e.d., then epoxied them together. I just cut off the connector and soldered it on the l.e.d. since the resistor is already in the Wii. Thats It!!
 
Remove these adsRemove these ads by Signing Up
Herodez5 years ago
are the L.E.D.'s 3mm or 5mm?
Question: I am modding my wii to accept either two SMD LEDs or just one Ultrabright Pink LED. What is the voltage coming out of the wii to the Gate assembly?