Print PDF
Favorite
Email
Step 2Handle
For the handle, I used a length of electrical conduit, EMT to be specific.
I ran the length of the frame, underneath and then used a conduit bender to get the curvature I needed.
I hammered the conduit a bit flat along the length under the frame so that it would have less of a tendency to roll, then drilled and screwed it to the frame at the front and back.
I used machine screws with wing nuts here so that the handle could be removed for transport.
I added two narrow aluminum straps from the handle to the front frame member as diagonal braces, also attached using machine screws with wing nuts.
I ran the length of the frame, underneath and then used a conduit bender to get the curvature I needed.
I hammered the conduit a bit flat along the length under the frame so that it would have less of a tendency to roll, then drilled and screwed it to the frame at the front and back.
I used machine screws with wing nuts here so that the handle could be removed for transport.
I added two narrow aluminum straps from the handle to the front frame member as diagonal braces, also attached using machine screws with wing nuts.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
