With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
This solution is very similar to the other DIY R-Straps on this site. The one distinction is that I believe this is safer. The other DIY R-Strap exa...
This is the spot where people have connected a strap to their camera for years. Let's use it.
You can use this to cut the nylon. Heat with a lighter so it cauterizes the cut as you go.
You'll need to get a grommet and the tool to set the grommet. You can find the 1 inch grommets at most hardware stores. However, these are usually b...
Start with your existing camera strap. And mold it to your desires. Each end of your old camera strap can be used to make a connector for one of the...
I chose to punch the hole for the grommet before cutting the strap so I was sure to have the right amount of space. Measure with the grommet ring in ...
Place the male end of the grommet through the hole. Then place the female part of the grommet over the male end. Then, using the punch that comes wi...
Here's where you heat the razor blade with a lighter and cut / cauterize the cuts you make on the straps. Notice there is a leather connection sewn...
This is about what the finished product should look like.
So now you thread the skinny part either onto the left or right mount point on the camera. I chose the left side so it didn't get in my way when I gr...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »