Introduction: Santa Sleigh Ornament

I made the sleigh and runners using Autodesk 123d software. I cut out the holes inside the sleigh using TinkerCad. Santa was modeled in clay and scanned. He was then merged into the sleigh using TinkerCad.

Comments

About This Instructable

195views

3favorites

License:

Bio: I am an author and a maker. My current project is Santa's Shop. I'm working on a science fiction type book--more later. @EngineerRigsby
More by MikeTheMaker:Happy Gear TableHappy FaceJittery Servo Repair
Add instructable to: