Introduction: Santa Sleigh

Picture of Santa Sleigh

This Santa Sleigh ornament was designed for the 3D printed ornament design challenge. To model this ornament I used Autodesk Inventor. I began with the base of the sleigh, then extruded from the side to get the overall shape of the sleigh. After shelling out that extrusion I added in the seat with a hook on top to hang from. I then moved down to the skis of the sled and finished off my design with a few fillets around the edges for a smoother appearance.

Step 1:

Step 2:


josephgregorydelong (author)2014-11-10

I really like your sleigh ornament.

seamster (author)2014-11-10

This is a fine looking ornament! Very well done.

About This Instructable




More by bwbusch2:Santa Sleigh
Add instructable to: