Print PDF
Favorite
Email
Step 3Storage
In order to keep track of the blade guard I added a loop of wire so I can hang it up on my saw storage loop (a.k.a. an old hand towel rack) when I'm using the saw.
To accomplish this put the pipe back in the vice with the slot facing down. Use a drill with a bit appropriate to the size of your wire to drill a hole in the pipe about a 1/2" from the end. Pass a wire through the hole and tie a couple of knots in it so that it forms a loop.
Your saw blade guard is now complete. Now put it on the blade or hang it up and use that saw!!!
To accomplish this put the pipe back in the vice with the slot facing down. Use a drill with a bit appropriate to the size of your wire to drill a hole in the pipe about a 1/2" from the end. Pass a wire through the hole and tie a couple of knots in it so that it forms a loop.
Your saw blade guard is now complete. Now put it on the blade or hang it up and use that saw!!!
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
