Instructables
Picture of Saw Cane
100_2416.JPG
100_2414.JPG
100_2413.JPG
100_2409.JPG
This is what happens when I have free time.......
 
Remove these adsRemove these ads by Signing Up

Step 1: What You Need

Picture of What You Need
100_2420.JPG
1. Cane
2. Hack saw blade
3. Gorilla Glue Super Glue ( Or any other kind of really strong glue)
4. Mini saw ( pictured below) ( you could use a knife but a saw is a lot easier)
5. Measuring tape (not necessary, but it helps)

Step 2: The Groove

Picture of The Groove
100_2413.JPG
100_2409.JPG
100_2415.JPG
Use the mini saw to cut a groove into the lower part of the cane long enough for the hack saw blade and deep enough to house the blade but still have most of it exposed.

Step 3: Time To Glue

Picture of Time To Glue
100_2415.JPG

Put the glue in the glue in the groove all the way down it's length. Now place the blade into the groove and hold it until the glue sets enough to hold the blade ( 30 seconds for the Gorilla Glue that I used).

Step 4: Finished

Picture of Finished
100_2416.JPG
100_2414.JPG
100_2413.JPG
100_2409.JPG

No have fun, be careful and don't hurt anybody or yourself ( I am not responsible if you do).
ghostfang2 years ago
ummmmmmm........................................
KentuckySam3 years ago
Ok...