Introduction: Scarab 2.0

Picture of Scarab 2.0

It has finally arrived! The Scarab 2.0! This is more of stunt plane than a dart. Though it looks advanced, it is very simple to make. It follows the same base as the 1.0 but with tweaks here and there. And yes, you can use printer paper for this one. And in case you were wondering, the 1.0 can be made with notebook or printer. Hope you enjoy!

Step 1: To Start

Picture of To Start

Take the paper and put it width wise. The fold it in half, the open it back up.

Step 2:

Picture of

Fold the corners to the crease, then fold the inside corners to the side and line it up.

Step 3:

Picture of

Flip it over and fold the corners to the crease

Step 4:

Picture of

Flip it over again and fold the nose about 3-4 inches or so, the fold it back up

Step 5:

Picture of

Fold it in half

Step 6:

Picture of

Fold the wings. They can be slanted or straight.

Step 7:

Picture of

Fold the back fins

Step 8:

Picture of

Fold the front fins

Step 9:

Picture of

Push up the wings and fins

Step 10: Finish

CONGRATULATIONS!!!!! You just completed the Scarab 2.0! To fly, give it nice throw with flick your wrist, it might work with a glider- type throw. Hope you enjoyed this instructable. If you have any ideas that make it look cooler or fly better, I'm open for suggestions.

Comments

About This Instructable

142views

3favorites

License:

More by 22181:Phantom G-2Scarab 2.0Scarab 1.0 Paper Airplane
Add instructable to: