Print PDF
Favorite
Email
Step 2Saw !
What we need to do first is cut out the base and clicker for the machine.
If you intend to make a single/stand alone unit only cut out one base and one clicker, If you intend to make a send/receive unit, cut two of each
Firstly take your ply board, and after measuring a 5" by 7" rectangle cut it out using your saw. I then cut the clicker section this time cutting a 3" by1.5" rectangle. I also cut a small square section that will act as a spacer between the base and the clicker. (See photo 3 if you can't figgure out what i intend to do)
If you intend to make a single/stand alone unit only cut out one base and one clicker, If you intend to make a send/receive unit, cut two of each
Firstly take your ply board, and after measuring a 5" by 7" rectangle cut it out using your saw. I then cut the clicker section this time cutting a 3" by1.5" rectangle. I also cut a small square section that will act as a spacer between the base and the clicker. (See photo 3 if you can't figgure out what i intend to do)
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
