With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
share what you made with text, photos, video, and files
gather your favorite instructables together
This is a small but important part of the greater project. known as Scratch Markup Language or SML What's the idea? We're creating a format for desc...
Soldering Iron 22 AWG Hook-Up Wire - Red 22 AWGHook-Up Wire - Yellow 22 AWG Hook-Up Wire - Black Helping Third Hand Solder Flush Cutters Needle Nose P...
4-PIN Connection Header 4-PIN Connection Housing Square ProtoBoard 4 x Female Connection Terminals
Cut a piece of hook-up wire at least 16-inches in length. This gives you enough room to come out of the mixer and into an Arduino sitting next to the ...
Strip away 1/8-inch of insulation on one end of the long wire.
Place the stripped end of the long wire into a Connection Terminal. Make sure the insulation stops in the gab between the two sets of wings.
Using the Universal Crimping Pliers, crimp the Connection Terminal onto the Long Wire.
Cut a new length of wire no longer than 3 inches. You want enough room to work with the wire but not much extra as this will be inside of the mixer.
Strip away 3/16-inch of the insulation to expose the short wire.
Lay the short wire on top of the connection terminal and solder the exposed portion of the wire to the conductor crimp section. Be careful to not get ...
Slide the connection terminal with both wires attached into the appropriate slot on the connection housing. Make sure it goes all the way in. If you a...
This is what it it should look like once you have all 3 Y cables in place.
Strip 3/16-inch of the insulation away from the end of the short wires.
Place the 4-PIN Connection Header through the holes in the ProtoBoard. Put the exposed ends of the short wire through the holes directly behind the co...
Now cut another short wire for the power pin. Attach the 4th Connection Terminal to one end and put it into the Connection Housing. Now solder the oth...
This is what you end up with.... a lovely Y cable. Hoooray! Hooray!
Because this wire is just bouncing around inside the mixer, I put a big ugly gob of hot glue over everything that was soldered.
Connect the 4-PIN Connection Header to the mixer.
Connect the Crossfader to the Connection Housing side of your high tech Y cable.
Carefully put the Y cable and the crossfader back into the mixer. Make sure the long wires stay out of the mixer.... seriously... do it.
We have a be nice comment policy. Please be positive and constructive.
How to Connect a Fader with Audio Input and Outputby jojporg
Make a Rotating Microphoneby noxidgerg
Digital to analog.by Computothought
Signal Flow Poster (with Chibitronics and Arduino)by womensaudiomission
HDDJ: Turning an old hard disk drive into a rotary input deviceby nvillar
Light controlled voltage sourceby Marc_Escobaem
ARDUINO MIDI FOUR-LINE MOTION CONTROLby InevitableCraftsLab
Talking Arduino Heart Rate Monitorby vm'shimmie
Make a Web Server using Arduinoby jordanfung
Beginner Arduinoby amandaghassaei
Download our new apps for iOS, Android and Windows 8!
© 2014 Autodesk, Inc.
By clicking "Create Account" you are indicating that you have read and agree to the Terms of service.
Already a member? Login »
Enter the email associated with your account and we will send you your username and a temporary password.
Not a member? Sign Up »