With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
This is a small but important part of the greater project. known as Scratch Markup Language or SML What's the idea? We're creating a format for desc...
Soldering Iron 22 AWG Hook-Up Wire - Red 22 AWGHook-Up Wire - Yellow 22 AWG Hook-Up Wire - Black Helping Third Hand Solder Flush Cutters Needle Nose P...
4-PIN Connection Header 4-PIN Connection Housing Square ProtoBoard 4 x Female Connection Terminals
Cut a piece of hook-up wire at least 16-inches in length. This gives you enough room to come out of the mixer and into an Arduino sitting next to the ...
Strip away 1/8-inch of insulation on one end of the long wire.
Place the stripped end of the long wire into a Connection Terminal. Make sure the insulation stops in the gab between the two sets of wings.
Using the Universal Crimping Pliers, crimp the Connection Terminal onto the Long Wire.
Cut a new length of wire no longer than 3 inches. You want enough room to work with the wire but not much extra as this will be inside of the mixer.
Strip away 3/16-inch of the insulation to expose the short wire.
Lay the short wire on top of the connection terminal and solder the exposed portion of the wire to the conductor crimp section. Be careful to not get ...
Slide the connection terminal with both wires attached into the appropriate slot on the connection housing. Make sure it goes all the way in. If you a...
This is what it it should look like once you have all 3 Y cables in place.
Strip 3/16-inch of the insulation away from the end of the short wires.
Place the 4-PIN Connection Header through the holes in the ProtoBoard. Put the exposed ends of the short wire through the holes directly behind the co...
Now cut another short wire for the power pin. Attach the 4th Connection Terminal to one end and put it into the Connection Housing. Now solder the oth...
This is what you end up with.... a lovely Y cable. Hoooray! Hooray!
Because this wire is just bouncing around inside the mixer, I put a big ugly gob of hot glue over everything that was soldered.
Connect the 4-PIN Connection Header to the mixer.
Connect the Crossfader to the Connection Housing side of your high tech Y cable.
Carefully put the Y cable and the crossfader back into the mixer. Make sure the long wires stay out of the mixer.... seriously... do it.
We have a be nice comment policy. Please be positive and constructive.
We noticed you attached photosto your comment.
How to Connect a Fader with Audio Input and Outputby jojporg
Make a Rotating Microphoneby noxidgerg
The Hip Hop Door Bellby 1up Living
Digital to analog.by Computothought
HDDJ: Turning an old hard disk drive into a rotary input deviceby nvillar
Control Ikea Dioder LED Strip with Arduino + 16X PWM LED Fader Boardby CuriousInventor.com
Light controlled voltage sourceby Marc_Escobaem
ARDUINO MIDI FOUR-LINE MOTION CONTROLby InevitableCraftsLab
Talking Arduino Heart Rate Monitorby vm'shimmie
BLE Arduino Bluetooth - RedBearLabby 330ohms
Join 2 million + to receive instant inspiration in your inbox.
Download our apps!
© 2015 Autodesk, Inc.
By clicking "Create Account" you are indicating that you have read and agree to the Terms of service.
Already a member? Login »
Enter the email associated with your account and we will send you your username and a temporary password.
Not a member? Sign Up »
Want to go pro?
First step is to sign up.
By clicking "Sign me up!" you are indicating that you have read and agree to the Terms of service.