Print PDF
Favorite
Email
Step 4Prepare the wood box
The box I bought has a fine wire mesh inlay on the lid
1. Cut a slot in the wire mesh so the screw on slider won't be obstructed.
2. Glue the head of a screw on the underside of the lid. This is were you will attach one end of the actuator.
3. Drill a small hole in the back of the box for big enough for the power cord to fit in.
1. Cut a slot in the wire mesh so the screw on slider won't be obstructed.
2. Glue the head of a screw on the underside of the lid. This is were you will attach one end of the actuator.
3. Drill a small hole in the back of the box for big enough for the power cord to fit in.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
